Apart from that, the devices from Motorola have been known to be quite an active player in the custom development as well. Be it for flashing custom ROMs, installing a custom recovery, or gaining administrative privileges by rooting, there’s quite a lot to look forward to. However, this is just one side of the coin. Trying out these tweaks could prove to be quite risky as well and there’s always a chance of things going south. If it is a softbrick or bootloop, then you could easily fix it by flashing the firmware via Fastboot. But what if the device is in a hard-bricked state. Well, if your device has an underlying Qualcomm chipset, then you could make use of the Emergency Download Mode and subsequently flash the Blank Flash file. This will then take you to the Fastboot Mode. After that, you may then flash the stock firmware via Fastboot Commands or using the LMSA Tool. So on that note, let’s get started with the tutorial to unbrick your Motorola device by flashing the Blank Flash file in EDL Mode.
Unbrick Motorola via Blank Flash and EDL Mode
The below process will wipe off all the data from your device. Moreover, it also requires an unlocked bootloader. Droidwin and its members wouldn’t be held responsible in case of a thermonuclear war, your alarm doesn’t wake you up, or if anything happens to your device and data by performing the below steps.
STEP 1: Install Android SDK
First and foremost, you will have to install the Android SDK Platform Tools on your PC. This is the official ADB and Fastboot binary provided by Google and is the only recommended one. So download it and then extract it to any convenient location on your PC. Doing so will give you the platform-tools folder, which will be used throughout this guide.
STEP 2: Install Qualcomm USB Drivers
Next up, download and install the Qualcomm HS-USB QDLoader 9008 Drivers on your PC. This will help your PC in identifying the connected device in the EDL Mode.
STEP 3: Download Blank Flash
Get hold of the blank flash file corresponding to your device from the Lolinet Mirrors. Once downloaded, extract it to the platform-tools folder on your PC.
STEP 4: Boot Motorola to EDL Mode
You will now have to boot your device to EDL Mode, for that, there are two broad approaches that you could take- using hardware key combinations or via Commands. The benefit of Hardware Keys is that you could use them at any point in time, irrespective of the current device state. On the flip side, there isn’t any universal key combination that we could suggest, though the first step is powering off your device. After that, you could try out one of the following permutations-
EDL Mode via Hardware Key Combination
Press and hold the Vol Up Vol Down and Power keysPress and hold the Vol Up OR Vol Down and Power keysPress and hold both the Volume keys and then connect it to the PC via USB cable.
EDL Mode via Blank Flash
If you are able to access the Fastboot Mode, then there are quite a few methods through which you could boot your Motorola device to the EDL Mode. Let’s start with the blank flash method-
EDL Mode via TWRP
EDL Mode via TWRP and ADB Command
STEP 5: Verify EDL Mode Connection
In most cases, the device wouldn’t show any prompt whether it is booted to EDL Mode or not. To verify the same, you will have to take the help of your PC. Here’s how- On the other hand, if it shows as QHUSB BULK, then reverify the driver installation, use a different USB cable, change USB ports, etc. Try out these tweaks until your device gets listed as Qualcomm HS-USB QDLoader 9008.
STEP 6: Unbrick Motorola via Blank Flash file and EDL Mode
That’s it. These were the steps to unbrick your Motorola device by flashing the Blank Flash file in EDL Mode. If you have any queries concerning the aforementioned steps, do let us know in the comments. We will get back to you with a solution at the earliest.
About Chief Editor
