Once you have obtained administrative privileges via Magisk, you will then be in a position to flash Modules, Xposed Framework, Viper4Android, Substratum Themes. However, carrying out these tweaks could prove to be risky as well. If you end up flashing an incorrect binary or flash it to an incorrect partition, then it could result in a brick or bootloop device. Well, even if that happens, you could easily unbrick your Cubot X30 device via Fastboot Commands. And in this guide, we will show you how to do just that. Follow along.
How to Unbrick Cubot X30 via Fastboot Commands
The below instructions are listed under separate sections for ease of understanding. Make sure to follow in the exact same sequence as mentioned. Droidwin and its members wouldn’t be held responsible in case of a thermonuclear war, your alarm doesn’t wake you up, or if anything happens to your device and data by performing the below steps.
STEP 1: Download Android SDK
To begin with, download and install the Android SDK Platform Tools. This is the official ADB binary file provided by Google and is used to execute ADB and Fastboot Commands. So download and then extract it to any convenient location on your PC. Doing so shall give you the platform-tools folder, which we will be using throughout this guide to unbrick Cubot X30 via Fastboot Commands.
STEP 2: Download Cubot X30 Stock Firmware
Next up, download the stock firmware for your Cubot X30 device. Once downloaded, extract it inside the platform-tools folder.
STEP 3: Boot Bootloop/Soft Bricked Cubot X30 to Fastboot Mode
STEP 5: Unbrick Cubot X30 via Fastboot Commands
That’s it. These were the steps to unbrick your Cubot X30 device via Fastboot Commands. The last command that you have executed (fastboot reboot) should automatically boot your device to the OS. You could then set up your device from scratch and start using it as before. On that note, we round off this guide. All your queries are welcomed in the comments section below.
About Chief Editor
